|
||
Partners
Future Cars
Company Information
Legal Statement | Privacy Policy | Advertise With Us | Contact Us
©2010 10w40.com. All rights reserved. Use of this site constitutes acceptance of 10w40.com's terms of service and privacy policy. The material on this site is for informational and educational purposes only.
INSTALLATION
1. Position intake manifold.
2. Install intake manifold retaining bolts, and tighten in sequence from the middle bolts towards the outside in a crisscross pattern. Torque fasteners to 12 N·m (105 in. lbs.)
3. Install EGR tube.
4. Install wire harness on intake manifold.
5. Connect electrical connectors for the following components:
Manifold Absolute Pressure (MAP) Sensor
Fuel Injectors
Electronic Throttle Control (ETC)
6. Install ignition wires.
7. Connect Brake booster hose, purge hose, and MUA hose (Make Up Air hose )
8. Install air inlet hose.
9. Connect negative cable to battery.
10. Install engine cover.