Free Repair Information and Great Prices from Autozone
Online Auto Repair Manuals - Brakes Repair
ALLData has online auto repair manuals available for most makes and models. Click here to get yours now!
Related Articles
-
Cost of Replacing the Alternator
Because this is the easier of the two, we'll go into it first. The cost of a new alternator varies by vehicle mak…
-
There are two reasons to replace the body mount bushings on a vehicle. The first is because the old ones have worn out with age - a common occurrence…
-
Progressive Suspension is a brand name for one of the premium factory made shock absorber series on the market. Used mainly on motorcycles and all-te…
-
When struts become worn, the vehicle will have excessive bounce, steering play, and probably squeak every time a bump is hit. Many people will wrongl…
Related Videos
-
This video shows you how to replace a headlight bulb in your vehicle.
More Videos
…
-
Know when to replace the brakes on your car by looking for these signs
More Videos
…
-
Learn how to check and replace a fuse in your car
More Videos
…
-
This video shows you how to properly replace a car battery.
More Videos
…
Latest Questions
should be from the back side
should be from the back side of the headlight inside the enging compartment. If you need more specifics the owners manuel should tell you how also.
Welcome to 10w40.com. To
Welcome to 10w40.com.
To replace the buld in your vehicle first make sure the replacement bulb is the same type and part number as the one that is being replaced.
To Replace:
Remove the headlight bezel retaining screws. Remove the bezel. If necessary, disconnect the turn signal lamp wires.
Remove the retaining ring screws from one or both lights.
Remove the retaining rings.
Remove the light from the housing. Disconnect the wiring connector from the back of the light.
Push the wiring connector onto the prongs at the rear of the new light.
Place the new light in the headlight housing. Position it so the embossed number in the light lens is on the top.
Place the retaining ring over the light and install the retaining ring screws. Tighten them slightly.
Check the aim of the headlight and adjust it, if necessary.
Install the headlight bezel. Secure it with the retaining screws.
Connect the turn signal lamp wiring (if it was disconnected).
Good Luck.