Shopping Cart
There are no products in your shopping cart.
| 0 Items | $0.00 |
Sponsored Links
Points Leaders for the Past 4 Weeks
| User | Points |
|---|---|
| bfree | 1,451 |
| jerryh20 | 860 |
| dayshifter1 | 612 |
| Kevin Wojdak | 83 |
| magic2756 | 65 |
July Gas Card Contest
Congratulations to our June Winners!
3 Prize Levels!
Accumulate points by participating in the 10w40.com Q&A community. Accumulate one of the top 3 point totals by July 31 to win free gas!
1st Place: $200 gas card
2nd Place: $100 gas card
3rd Place: $50 gas card
How To Play
User login
Poll
Video from FutureCars.com
i have a 1994 GMV Vandura 2500 8 cylinder van , The spindal broke on the driver side so i replaced the spindal and now the abs light comes on and off and so does the check engine light any ideas
Sponsored Links
Auto Repair Manuals
Haynes Auto Repair Manuals
We have Auto Repair Manuals available from Haynes. We have the lowest prices available...guaranteed. Each manual is written and photographed from “hands-on” experience gained by a complete teardown and rebuild of the vehicle. Click here to get your Haynes Auto Repair Manual...
Online Auto Repair Manuals
Online auto repair manuals are available for AllData and Mitchell1. They are easy to use and contain all of the original manufacture's repair, diagnostic and repair procedures. Navigation and search tools allow you to quickly get to the info you need to do the job. Click here to get your Online Auto Repair Manual...
there might be 2 problems as
there might be 2 problems as where the abs module will not set an engin light. check the front speed sensors frist, if the wiring is not damaged, replace the speed sensor on the spindel that was replaced. let us know.
Spindle problem may have
Spindle problem may have damaged ABS wheel speed sensor, this would cause the light to come on.
Easy test: (engine off--ign switch off)
raise the driver's side wheel.
Disconnect the wheel speed sensor.
connect volt meter (set to read AC current) to the two connectors inside of the abs speed sensor connector
Spin the wheel by hand
the meter should read about 2 volts if the sensor is good.