I'm working on a 1990 f150 4x4 4.6 liter and would like to know how to remove thr hydralic linethat go's into the trans to the slave cylinder.

Related Articles

• 
  Cylinder Head Torque Settings
  Removal and replacement of the cylinder heads and gaskets on a vehicle is one of the most comprehensive tear downs a mechanic can do outside of a rebu…
• 
  Cylinder Head Torque Specs
  Likely the most important installation concern when replacing cylinder heads, due to a gasket change or warping, is proper torque in the proper sequen…
• 
  4L60e Transmission Problems
  Most common problems with the General Motors 4L60e transmission are diagnosed through the power control module (PCM) and its diagnostics readout. The…
• 
  Tools To Change Spark Plugs
  One of the easiest home DIY projects in most vehicles is to change out the spark plugs. Plugs provide the spark that ignites the fuel in gasoline, nat…

Related Videos

• 
  How to Remove a Broken Key
  Find out how you can remove a broken key from the ignition More Videos …
• 
  How to Remove Key Scratches on a Car
  This video shows you how to remove small key scratches on a car. More Videos …
• 
  How to Remove Small Bubbles in an Automotive Paint Job
  Does you car have a bubble in the paint job? If so, this video will show you how to remove them. …
• 
  How to Remove a Car Door Panel
  This video shows you how to properly remove a car door panel. More Videos …

Latest Questions

• 
  where is the clutch slave cylinder located at on m...
  …
• 
  I have a 1987 ford f150 4-9 4 speed.A friend repla...
  …
• 
  do i have to remove the transmission on my ford f1...
  …
• 
  i have a 1990 gmc and my hydrolic cluch has went o...
  …