Auto Repair Q&A
Popular
- How to drive stick
- Transmission Repair
- Engine Repair
- Air Conditioning Repair
- Alternator Repair
- Timing Belt Replacement
- Cooling System Repair
- Spark Plug Replacement
- Brakes Repair
Engine
- Camshaft Repair
- Blower Motor Repair
- Carburetor Repair
- Choke Repair
- Engine Valve Repair
- Gas Tank Repair
- Head Gasket Repair
- Intake Repair
- Spark Plug Replacement
- Timing Adjustment
- Timing Belt Replacement
Cooling System
Brakes
- ABS Repair
- Brake Light Replacement
- Brake Pad Replacement
- Brake Replacement
- Brakes Repair
- Disc Brake Repair
- Drum Brake Replacement
- Resurface Rotors
Suspension
- Axle Repair
- Bearing Repair
- Bushings Repair
- CV Joint Repair
- Power Steering Rack Repair
- Steering Repair
- Steering Wheel Repair
- Suspension Repair
- Tire Repair
- Tire Replacement
- Wheel Bearing Replacement
Transmission
- Clutch Bleeding
- Clutch Repair
- Clutch Replacement Transmission Repair
- Transmission Service Cost
- Automatic Transmission Flush
- Auto Transmission Fluid
Exhaust/Emissions
Electrical
- Alternator Repair
- Car Battery Replacement
- Charging System Repair
- Electrical System Repair
- Fuse Repair
- Starter Repair
- Starter Wiring
Body
- Auto Touch Up Paint
- Paint Chip Repair
- Window Tint Film
- Windshield Repair
- Replacement Trunk Beds
- Rear View Mirror Replacement
Interior
- Auto Interior Repair
- Dash Repair
- Headliner Replacement
- Interior Door Panel Replacement
- Car Audio Repair
- Speedometer Calibration
- Speedometer Repair
Understand
- Auto Repair
- Auto Repair Manuals
- Diagnose Auto Problems
- Auto Maintenance
- Auto Performance
- Auto How To
after putting it in base
after putting it in base time, set dist. to zero.
base time is set by disconnecting the timming check connector. here's location of connector.
The correct location of the Set Timing Connector is inside the cab where the Heater Box and the carpet meet on the passenger side floor.
Pull carpet back to expose the single wire and connectors on the outside of the control module harness. The wire colors are tan with a black stripe.
best advise i can give you is
best advise i can give you is hook up a vacuum gauge to your intake vacuum source around the base of Carb or Throttle body and move the disst till you get the best vacuuam reading and then lock it up.